Page 501 - Manual Oficina XP 1000 14-16

ELECTRICAL

Refer to Chapter 3 and 10 for additional ECT sensor 8. Add the required amount of coolant and bleed the
information. Polaris dealers can test the sensor by using system (see Chapter 3 – Cooling System Bleeding
Digital Wrench® Diagnostic Software (dealer only). Procedure, page 3.20).

TEMPERATURE °F (°C) RESISTANCE
68 °F (20 °C) 2.5 k Ω ± 6%

86 °F (30 °C) 1.7 k Ω ± 6%
104 °F (40 °C) 1.2 k Ω ± 6%

122 °F (50 °C) 834 Ω ± 6%
140 °F (60 °C) 596 Ω ± 6%
158 °F (70 °C) 435 Ω ± 6%

176 °F (80 °C) 323 Ω ± 6%
194 °F (90 °C) 243 Ω ± 6%

212 °F (100 °C) 186 Ω ± 6%

ECT SENSOR REPLACEMENT
1. Remove the throttle body. (see Chapter 4 – Throttle
Body Removal, page 4.34).

2. Be sure the engine has cooled enough to work on.
3. Disconnect the vehicle harness from ECTsensor.
4. Drain the coolant so the level is below the sensor
(see Chapter 2 – Coolant Drain / Fill, page 2.18).
5. Using a wrench, remove and replace the sensor,
applying a light coating of thread sealant to the
sensor threads q to aid installation.

11

6. Torque the new ECT sensor to specification and
connect the vehicle harness to the sensor.
TORQUE
ECT Sensor:
17 ft-lb (23 Nm)

7. Reinstall the throttle body.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 11.29
© Copyright Polaris Industries Inc.