Page 499 - Manual Oficina XP 1000 14-16

ELECTRICAL

3. Carefully lift and remove headlamp assembly from TAILLIGHT REPLACEMENT
the bumper. Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
HEADLAMP INSTALLATION volts and that a ground path is present.
1. Install the headlamp adjustment springs onto the 1. Disconnect the wire harness q.
front bumper mounting bosses.
2. Insert the three T-25 headlamp mounting screws into
the headlamp assembly mounting holes.
3. Maneuver the headlamp assembly into position. Be
sure all three headlamp springs w and mounting
screws q are properly aligned with mounting bosses
e on the front bumper.

2. While holding the taillight assembly, remove the
three nuts w retaining the taillight assembly and
remove it from the rear fascia.

DASH LIGHT
The LED light will remain ON for approximately 30
seconds after key has been switched to the OFF
position.
4. Fully tighten all three headlamp screws until the
headlamp assembly is fully seated. Back headlamp
mounting screws off 1/8” to 1/4” (2-3 turns).
5. Install the front bumper as shown in Chapter 5 if
previously removed.

6. Connect headlamp electrical connector to the
headlamp assembly.
7. Perform the “Headlight Adjustment” procedure as
shown in this chapter.

11

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 11.27
© Copyright Polaris Industries Inc.