Page 98 - Manual Oficina XP 1000 14-16
P. 98

ENGINE / COOLING SYSTEM

                COOLING SYSTEM BLEEDING                              6. Open the bleed screw e to allow any trapped air to
                PROCEDURE                                                escape. Close the bleed screw once a steady stream
                                                                         of coolant begins to drain out.
                                     WARNING

                  Always wear safety glasses and proper shop clothing
                 when performing the procedures in this manual. Failing
                     to do so may lead to possible injury or death.


                                   CAUTION
                    Use caution when performing these procedures.
                  Coolant may be hot and may cause severe injury or
                                      burns.


                                     NOTE
                 If the coolant level is LOW in the radiator, or if there are
                  leaks in the system, the coolant system will not draw
                           coolant from the reservoir tank.          7. Tighten the bleed screw to specification, top off
                                                                         coolant and properly install the pressure cap.
                1. Allow engine and cooling system to cool down.
                                                                                         TORQUE
                                   CAUTION                                           Coolant Bleed Screw:
                 Be sure the engine has cooled and no pressure is built                89 in-lb (10 Nm)
                 up in the cooling system before removing the pressure
                  cap. The coolant may be hot and could cause severe  8. Start the engine and allow it to idle until the coolant
                                  injury or burns.                       fan has cycled two times.
                                                                     9. Allow engine and cooling system to completely cool
                2. Remove the hood.                                      down (see CAUTION).
                3. Remove the recovery bottle cap q and fill the bottle  10. Remove the pressure cap. Add the necessary
                   to the MAX line.                                      amount of Polaris Premium Antifreeze to the radiator
                                                                         filler neck.
                                                                     11. Open the bleed screw to allow any trapped air to
                                                                         escape. Close the bleed screw once a steady stream
                                                                         of coolant begins to drain out.
                                                                     12. Tighten the bleed screw to specification, top off
                                                                         coolant and properly install the pressure cap.
                                                                                         TORQUE
                                                                                     Coolant Bleed Screw:
                                                                                       89 in-lb (10 Nm)

                                                                     13. Fill the recovery bottle to the MAX line.
                                                                     14. Reinstall the hood.
                4. Remove the pressure cap w and add the necessary   15. Reinstall the seats and engine service panel.
                   amount of Polaris Premium Antifreeze to the radiator
                   filler neck.
                5. Remove the seats, engine service panel and divider
                   panel heat shield to access the coolant bleed screw.










                3.20                                                   9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
                                                                                               © Copyright Polaris Industries Inc.
   93   94   95   96   97   98   99   100   101   102   103