Page 123 - Manual Oficina Polaris RZR XP 1000 17-18
P. 123

ENGINE / COOLING SYSTEM

                   COOLING SYSTEM BLEEDING                               6. Open the bleed screw e to allow any trapped air to
                   PROCEDURE                                                 escape. Close the bleed screw once a steady stream
                                                                             of coolant begins to drain out.
                                         WARNING

                     Always wear safety glasses and proper shop clothing
                    when performing the procedures in this manual. Failing
                         to do so may lead to possible injury or death.


                                       CAUTION
                                                                                                                              3
                       Use caution when performing these procedures.
                      Coolant may be hot and may cause severe injury or
                                          burns.

                                         NOTE
                    If the coolant level is LOW in the radiator, or if there are
                      leaks in the system, the coolant system will not draw
                               coolant from the reservoir tank.          7. Tighten the bleed screw to specification, top off
                                                                             coolant and properly install the pressure cap.
                   1. Allow engine and cooling system to cool down.
                                                                                             TORQUE
                                       CAUTION                                          Coolant Bleed Screw:

                     Be sure the engine has cooled and no pressure is built                89 in-lb (10 Nm)
                     up in the cooling system before removing the pressure
                     cap. The coolant may be hot and could cause severe  8. Start the engine and allow it to idle until the coolant
                                      injury or burns.                       fan has cycled two times.
                                                                         9. Allow engine and cooling system to completely cool
                   2. Remove the hood.
                                                                             down (see CAUTION).
                   3. Remove the recovery bottle cap q and fill the bottle  10. Remove the pressure cap. Add the necessary
                       to the MAX line.
                                                                             amount of Polaris Premium Antifreeze to the radiator
                                                                             filler neck.
                                                                         11. Open the bleed screw to allow any trapped air to
                                                                             escape. Close the bleed screw once a steady stream
                                                                             of coolant begins to drain out.
                                                                         12. Tighten the bleed screw to specification, top off
                                                                             coolant and properly install the pressure cap.
                                                                                             TORQUE
                                                                                        Coolant Bleed Screw:
                                                                                           89 in-lb (10 Nm)
                                                                         13. Fill the recovery bottle to the MAX line.

                                                                         14. Reinstall the hood.
                   4. Remove the pressure cap w and add the necessary    15. Reinstall the seats and engine service panel.
                       amount of Polaris Premium Antifreeze to the radiator
                       filler neck.
                   5. Remove the seats, engine service panel and divider
                       panel heat shield to access the coolant bleed screw.









                   9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual                                      3.15
                   © Copyright Polaris Industries Inc.
   118   119   120   121   122   123   124   125   126   127   128