Page 183 - Manual Oficina Polaris RZR XP 1000 17-18
P. 183
ENGINE / COOLING SYSTEM
11. Install the valve adjustment tappet i for each valve CYLINDER HEAD INSTALLATION
in the order they were removed. 1. Rotate the engine so the cylinder is facing up.
2. Remove the Cylinder Holding & Camshaft Timing
Plate (PU-50563) q from the cylinder.
3
NOTICE
Refer to Valve Clearance Adjustmentpage 3.81
procedure for proper tappet selection.
NOTICE
Once the cylinder head is removed, nothing retains the
NOTICE cylinder to the engine. DO NOT rotate the engine
without using the Cylinder Holding & Camshaft Timing
If any valve train components were replaced, refer to
“Valve Clearance Adjustment”page 3.81 procedure Plate (PU-50563).
prior to Camshaft Installation / Timingpage 3.76
procedure. 3. Prepare cylinder head gasket sealing surfaces by
cleaning thoroughly to remove all residue. The head
gasket must be installed clean and dry, free from oil
or grease.
NOTICE
Do not touch sealing surfaces of gasket.
4. Guide cam chain w through a new head gasket e
and install the gasket on the cylinder, locating it on
the alignment pins.
5. Carefully set the cylinder head r in place on
alignment pins.
6. Install new bolts and finger tighten the six cylinder
head bolts t evenly.
9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 3.75
© Copyright Polaris Industries Inc.
