Page 321 - Manual Oficina Polaris RZR XP 1000 17-18

TRANSMISSION

11. Look down into the transmission housing to see the 16.Assemble the reverse shaft assembly and input shaft
snorkel locking screw hole opening k to reference assembly if previously disassembled (see
your starting point. illustrations).

NOTICE
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.
6
12.Slowly rotate the snorkel tube clockwise while
counting the number of notches passing through the
hole opening as you rotate the tube. Rotate the
snorkel tube to the 3rd notch from the ‘zero’ backlash
position obtained in step 11.
13.Check the pinion shaft gear backlash again by feel. If REF DESCRIPTION
the pinion shaft gear lash appears to be too tight,
rotate the snorkel shaft clockwise to the next notch l Reverse Shaft
(4th notch).
1( Low Gear
14.Once the backlash is set, apply Loctite 242 ™ to the
®
threads and install the locking screw to secure the 2) Engagement Dog
snorkel tube. Torque the locking screw to
specification. 2! Reverse Sprocket
TORQUE 2@ Silent Chain
Snorkel Locking Screw: 2# Snap Ring
10 ft-lb (14 Nm)
2$ Bearing
Transmission Assembly 2% High Gear

NOTICE 2^ Input Shaft
The snorkel shaft and pinion shaft must be installed
prior to transmission assembly. The snorkel shaft
cannot be installed after assembling the transmission.

15.Clean both transmission case halves thoroughly.
Inspect case half mating surfaces for damage.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 6.29
© Copyright Polaris Industries Inc.