Page 331 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

FRONT BEARING CARRIER INSTALLATION 6. Install new brake caliper mounting bolts and torque
1. Install drive shaft axle through the backside of the to specification.
bearing carrier.
TORQUE
2. Install the upper and lower ball joint ends into the Front Caliper Mounting Bolts:
front bearing carrier.
30 ft-lb (41 Nm)
3. Install new pinch bolts q and nuts. Torque to
specification.
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.

7. Install the steering tie rod end r onto the front
bearing carrier.

NOTE
Refer to the photo below to ensure proper placement of
the tie rod end.

TORQUE
Ball Joint Pinch Bolts:
42 ft-lbs (57 Nm)

4. Apply Anti-Seize to drive shaft axle splines. 7

5. Install front wheel hub assembly w, cone washer(s)
e, and hand tighten the castle nut. Install washers
with domed side out.

8. Torque the tie rod end fastener t to specification
and install a new cotter pin t.
TORQUE
Tie Rod End Fastener:
15 ft-lbs (20 Nm) + 90°

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 7.5
© Copyright Polaris Industries Inc.