Page 333 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

6. Remove the two brake caliper mounting bolts t. 9. Remove the bearing carrier from the rear drive shaft
Remove the rear brake caliper assembly. and trailing arm.

10. Rotate bearing by hand and check for smooth
CAUTION
rotation. Visually inspect bearing for moisture, dirt, or
Do not hang the caliper by the brake line. Use wire to corrosion.
hang caliper to prevent damage to the brake line.
NOTE
7. Remove the rear wheel hub and brake disk Due to extremely close tolerances and minimal wear,
assembly. the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
8. Remove the five remaining bolts y that attach the spots, discoloration, or corrosion. The bearings should
rear bearing carrier to the trailing arm. Discard the turn smoothly and quietly, with no detectable up and
nuts. down movement and minimal movement sideways
between inner and outer race.
7
11. Replace bearing if moisture, dirt, corrosion, or
roughness is evident.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 7.7
© Copyright Polaris Industries Inc.