Page 335 - Manual Oficina Polaris RZR XP 1000 17-18

FINAL DRIVE

REAR BEARING CARRIER INSTALLATION 4. Install rear wheel hub assembly w, cone washers e,
1. Install drive shaft through the backside of the bearing and hand tighten the castle nut. Install washers with
carrier. domed side out.

5. Install the rear brake caliper assembly and new bolts
2. Install the four fasteners q that attach the rear
bearing carrier to the trailing arm. Install the one r. Torque to specification.
fastener w that attaches the upper radius rod to the
bearing carrier. Torque bolts to specification.
NOTE

Use new nuts upon installation of the rear bearing
carrier.

7

TORQUE
Rear Caliper Mounting Bolts:
40 ft-lbs (54 Nm)

TORQUE
Bearing Carrier to Trailing Arm Bolts:
42 ft-lb (54 Nm)
Radius Rod to Bearing Carrier Fasteners:
M10: 40 ft-lb (54 Nm)
M12 (outer): 50 ft-lb + 90° (68 Nm + 90°)
3. Apply anti-seize to drive shaft splines.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 7.9
© Copyright Polaris Industries Inc.