Page 376 - Manual Oficina Polaris RZR XP 1000 17-18

STEERING / SUSPENSION

UPPER STEERING SHAFT INSTALLATION 5. Install a new upper steering shaft pinch bolt and nut.
Torque pinch bolt to specification.
NOTE
TORQUE
If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned Upper Steering Shaft Pinch Bolt:
on the power steering stub shaft. 15 ft-lbs (20 Nm)

6. Reconnect both electrical harnesses onto the power
CAUTION steering unit. Be sure the connectors snap into
Striking the steering wheel or steering shaft can place.
permanently damage the EPS unit and cause a Power 7. Reinstall the black plastic cover over the power
Steering Fault. steering unit and install the two Torx fasteners.
8. Turn the key switch on and test EPS operation.
1. Install the upper steering shaft and align the skip-
tooth spline q on the power steering stub shaft with
the opening w in the upper steering shaft.

2. Install the pivot tube and torque fasteners to
specification.
TORQUE
Pivot Tube Fasteners:
8 ft-lb (11 Nm)

3. Install the tilt shock and torque fastener to
specification.

TORQUE
Tilt Shock Fastener:
7 ft-lb (10 Nm)

4. Be sure the front wheels are pointing straight ahead
and install the steering wheel and retaining nut.
Torque the nut to specification and reinstall the
plastic wheel cover.

TORQUE
Steering Wheel Nut:
65 ft-lbs (88 Nm)

8.10 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.