Page 379 - Manual Oficina Polaris RZR XP 1000 17-18
P. 379
STEERING / SUSPENSION
14. Install the nut retaining the front stabilizer bar link to 19. Examine A-arm bushings and pivot tube. Replace if
the upper control arm.. Torque fasteners to worn. Discard hardware.
specification.
20. If not replacing the A-arm, thoroughly clean the A-
TORQUE arm and pivot tube.
Stabilizer Bar Link Fasteners: 21. Install new ball joint into A-arm. Refer to “Ball Joint
40 ft-lb (54 Nm) Replacement” section.
22. Insert new A-arm bushings and pivot tube into new
15. Attach shock to A-arm with fastener. Torque lower A-arm. A light press force may be needed.
shock bolt to specification.
23. Install new lower A-arm assembly onto vehicle
TORQUE frame. Torque new bolt to specification.
Front Shock Mounting Bolts: 24. Insert lower A-arm ball joint end into the bearing
42 ft-lbs (57 Nm) carrier. Install lower ball joint pinch bolt into the
bearing carrier and torque bolt to specification.
WARNING
Lower A-Arm
Upon A-arm installation, test vehicle at low speeds
16. Remove lower ball joint pinch bolt t from bearing
carrier. before putting into service.
TORQUE
Lower A-arm Bolts:
42 ft-lb (57 Nm)
Front Ball Joint Pinch Bolts:
42 ft-lbs (57 Nm)
FRONT STABILIZER BAR REMOVAL
1. Remove the nut q retaining the front stabilizer bar
link w to the upper control arm eon both sides. 8
17. Using a soft face hammer, tap on bearing carrier to
loosen the lower A-arm ball joint end while pushing
downward on the lower A-arm. Completely remove
the ball joint end from the bearing carrier.
18. Loosen and remove the lower A-arm front through-
bolt fastener y and rear through-bolt fastener u.
Remove the lower A-arm from the vehicle.
2. Remove the Fasteners retaining the stabilizer bar
mount to the frame.
3. Remove the stabilizer bar out the side of the vehicle.
9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 8.13
© Copyright Polaris Industries Inc.
