Page 383 - Manual Oficina Polaris RZR XP 1000 17-18

STEERING / SUSPENSION

4. Remove the lower radius rod mounting bolt r, nut 8. Remove the bearing carrier from the rear drive shaft
and washer from the bearing carrier. Swing radius and trailing arm.
rod down. Discard the nut.

9. Rotate bearing by hand and check for smooth
5. Remove the two brake caliper mounting bolts t. rotation. Visually inspect bearing for moisture, dirt, or
corrosion. Replace bearing if moisture, dirt,
corrosion, or roughness is evident (see “Rear
Bearing Replacement” in the Final Drive chapter).
10. Remove the four fasteners u that secure the brake
line retainers to the trailing arm.
11. Remove the lower stabilizer bar linkage fastener.
Discard the nut.
12. Support trailing arm with suitable jack stand or
support.
13. Remove the lower shock bolt. Discard the nut.

8
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.

6. Remove the rear wheel hub and brake disk
assembly.

7. Remove the five remaining bolts y that attach the
rear bearing carrier to trailing arm. Discard the nuts.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 8.17
© Copyright Polaris Industries Inc.