Page 384 - Manual Oficina Polaris RZR XP 1000 17-18
P. 384
STEERING / SUSPENSION
14. Remove the front trailing arm bolt i. Discard the 18. Torque all fasteners to specification.
nut.
TORQUE
Trailing Arm to Main Frame:
(Trailing arm spherical bearing bolt)
70 ft-lb (95 Nm)
Rear Shock Mounting Bolts:
70 ft-lbs (95 Nm)
Rear Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
Radius Rod Mounting Bolts:
M10: 40 ft-lb (54 Nm)
M12 (outer): 50 ft-lb + 90° (68 Nm + 90°)
15. Remove trailing arm from vehicle. Visually inspect
trailing arm, bushings, o-rings and spherical bearing Bearing Carrier to Trailing Arm Bolts:
for wear. If bearing requires replacement, refer to 42 ft-lb (54 Nm)
“Trailing Arm Spherical Bearing Replacement”.
Rear Brake Caliper Mounting Bolts:
16. Replace trailing arm if physically damaged.
40 ft-lbs (54 Nm)
17. Reverse this procedure to reinstall rear trailing arm.
Rear Wheel Hub Castle Nut:
NOTE 110 ft-lbs (149 Nm)
Use new fastener nuts upon installation of the rear
trailing arm and bearing carrier. Wheel Nuts:
120 ft-lbs (163 Nm)
WARNING
Upon rear trailing arm installation, test vehicle at low
speeds before putting into service.
8.18 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
