Page 97 - Manual Oficina Polaris RZR XP 1000 17-18

MAINTENANCE

7. Remove the drain plug w and allow fluid to drain 2. Inspect shift cable, clevis pin, pivot bushings r, and
completely. dust boot e. Replace if worn or damaged.

2

8. Clean the drain plug magnetic surface. 3. If adjustment is required, loosen the lower jam nut y
and pull the cable out of the mount w to move the
9. Reinstall the drain plug and torque to specification.
upper jam nut t.
10. Add the recommended amount of fluid through the fill
hole. Maintain the fluid level even with the bottom
threads of the fill plug hole.
FLUID CAPACITY
Recommended Front Gearcase Fluid:
Demand Drive Fluid 2877922 (quart)
Capacity: approx. 8.5 oz (250 mL)

11. Reinstall the fill plug and torque to specification.
TORQUE
Front Gearcase Fill / Drain Plug Torque:
10 ft-lbs (14 Nm)
4. Adjust the shift cable so there is the same amount of
12. Check for leaks. Dispose of used fluid properly. cable travel when shifting slightly past HIGH gear
and PARK.
SHIFT CABLE INSPECTION / ADJUSTMENT
5. Thread the upper or lower jam nut as required to
Shift cable adjustment may be necessary if symptoms obtain proper cable adjustment.
include:
NOTE
• No gear position or AWD display on instrument cluster
This procedure may require a few attempts to obtain
• Ratcheting noise on deceleration the proper adjustment.
• Inability to engage into a gear
6. Once the proper adjustment is obtained, place the
• Excessive gear lash (noise) shift cable and upper jam nut into the mount. Tighten
• Gear selector moving out of desired range the lower jam nut against the mount.
7. Start engine and shift through all gears to ensure the
1. Locate the shift cable q attached to the transmission shift cable is properly adjusted. If transmission still
case in the right rear wheel well area.
ratchets after cable adjustment, the transmission will
require service.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 2.51
© Copyright Polaris Industries Inc.