Page 240 - Manual Oficina Polaris Sportsman 570 2014 a 2016
P. 240

ENGINE / COOLING SYSTEM


                COOLING SYSTEM PRESSURE TEST                         3. Remove any obstructions with compressed air or low
                                                                         pressure water.
                1. Remove the center cover under the front rack.
                                                                                         CAUTION
                                     WARNING
                                                                      Washing the vehicle with a high-pressure washer could
                  Never remove pressure cap when engine is warm or       damage the radiator fins and impair the radiators
                 hot. The cooling system is under pressure and serious  effectiveness. Use of a high-pressure washer is not
                                 burns may result.                                      recommended.
                       Allow the engine to cool before servicing.

                2. Remove pressure cap and pressure test the cooling
                   system using a commercially available pressure
                   tester.                                           COOLANT DRAIN / RADIATOR REMOVAL
                                                                     Coolant Drain
                3. The system must maintain 10 psi for five minutes or
                   longer. If pressure loss is evident within five minutes,  1. Remove the center cover from the front cab.
                   check the filler neck, radiator, hoses, clamps and
                   water pump weep hole for leakage.                                       WARNING
                                                                       Never drain the coolant when the engine and radiator
                                                                       are warm or hot. Hot coolant can cause severe burns.
                PRESSURE CAP TEST                                               Allow engine and radiator to cool.
                1. Remove    the  hood  from  the  front  cab  (see
                   “WARNING” under “Cooling System Pressure Test”).  2. Slowly remove the pressure cap q to relieve any
                                                                         cooling system pressure.
                2. Remove pressure cap and test using a pressure cap
                   tester (commercially available).
                3. The pressure cap relief pressure is 13 psi. Replace
                   cap if it does not meet this specification.
                RADIATOR














                                                                     3. Place a suitable drain pan underneath the water
                                                                         pump inlet housing on the front right-hand side of the
                                                                         vehicle.
                                                                     4. Drain the coolant from the cooling system by
                                                                         removing the lower coolant hose from the water
                                                                         pump housing then the lower radiator outlet w as
                 REF    DESCRIPTION                                      shown. Properly dispose of the coolant.
                  q     Fan Motor                                    5. Allow coolant to completely drain.
                  w     Shroud                                       6. Place a suitable drain pan underneath the lower
                                                                         engine hose on the right-hand rear side of the
                  e     Radiator                                         vehicle.

                1. Check radiator air passages for restrictions or   7. Remove the hose and completely drain the engine.
                   damage.                                           Radiator Removal
                2. Carefully straighten any bent radiator fins.      1. Remove the front bumper.






                3.118                                           9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
                                                                                                © Copyright Polaris Industries Inc.
   235   236   237   238   239   240   241   242   243   244   245