Page 242 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

2. Remove Left side panel, required PVT ducting and 7. Fill the radiator until a steady stream of coolant
Center panel under the front rack. begins to drain out of the bleed screw e.
3. Remove the pressure cap q and add the necessary
amount of Polaris Premium Antifreeze to the radiator
filler neck.

8. Tighten the bleed screw to specification, top off
coolant and properly install the pressure cap.

TORQUE
Coolant Bleed Screw:
4. Remove the recovery bottle cap w and fill the bottle
to the MAX line. 6 ft-lbs (8 Nm)

9. Start the engine and allow it to idle until the coolant
fan has cycled.
10. Allow engine and cooling system to completely cool
down (see CAUTION).
11. Remove the pressure cap. Add the necessary
amount of Polaris Premium Antifreeze to the radiator
filler neck.
12. Open the bleed screw to allow any trapped air to
escape. Close the bleed screw once a steady stream
of coolant begins to drain out.
13. Tighten the bleed screw to specification, top off
coolant and properly install the pressure cap.
5. Remove the cargo box access cover to gain access TORQUE
to the coolant bleed screw that is on top of the
thermostat housing. Coolant Bleed Screw:
6 ft-lbs (8 Nm)
6. Open the bleed screw e to allow any trapped air to
escape.
14. Fill the recovery bottle to the MAX line.
15. Reinstall the Left side panel, required PVT ducting
and Center panel under the front rack.

3.120 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.