Page 298 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

8. By hand, lightly press the flywheel inward while STATOR REMOVAL
rotating the freewheel gear counter clock-wise. Fully
install the flywheel until seated on the crankshaft NOTE
taper.
Test stator wire continuity before removing it from the
housing.

1. Remove the stator cover as outlined in the ”Water
Pump Mechanical Seal / Oil Seal Replacement”
procedure” in this chapter.

CAUTION
The flywheel contains powerful magnets. Use caution
when removing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
result.

2. Remove and discard the stator cover gasket.

9. Install the flywheel washer. CAUTION
10. Hold flywheel with commercially available strap Be sure engine coolant does not contaminate the
wrench. engine oil during stator cover service.
11. Torque new flywheel nut e to specification.
3. Remove the 3 bolts (C) that secure the stator to the
stator cover.
4. Remove the 2 bolts that secure the stator wire
routing bracket (D) to the stator cover.
5. Remove the stator (E) from the stator cover.

TORQUE
Flywheel Retaining Nut:
133 ft-lbs (180 Nm)Torque to specification, back of
180 degrees, retorque to specification.

12. Install starter idler gear and shaft.

3.176 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.