Page 299 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

STATOR / STATOR COVER INSTALLATION OIL PUMP REMOVAL
1. Clean and degrease screws and threads in stator
housing.
2. Clean mounting surfaces of stator and housing.
3. Apply crankcase sealant to edges of rubber stator
grommet as shown below.
4. Set the stator in housing and press wire grommet
into slot on housing.
5. Apply Loctite® 242™ to end (8-10 threads) of (3) 3
stator screws (C) and the (2) wire routing bracket
screws (D).
6. Install all (5) screws and torque to specification.

1. Remove the fasteners q retaining the intermediate
(mag) portion of the crank case and remove this
section of the crank case.

TORQUE
Stator Cover Bolts
9 ft-lbs (12 Nm)Apply Loctite® 242™
2. Rotate the crankshaft to TDC position by aligning the
timing hole w in crankcase with a timing hole in the
TORQUE
crankshaft. Insert a 1/4” drive socket extension
Stator Wire Bracket Bolts through the crankcase and into the crankshaft
6 ft-lbs (9 Nm)Apply Loctite® 242™ locating hole.

7. Install a new stator cover gasket into the engine.
8. Install the stator cover as outlined in this chapter.

CAUTION

The flywheel contains powerful magnets. Use caution
when installing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
result.

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 3.177
© Copyright Polaris Industries Inc.