Page 402 - Manual Oficina Polaris Sportsman 570 2014 a 2016

PVT SYSTEM

PVT SYSTEM SERVICE 8. Remove driven clutch alignment washer(s) from the
transmission input shaft. Note number of washers.
DISASSEMBLY

Some fasteners and procedures will vary. Refer to the
appropriate parts manual for proper fasteners and
fastener placement.
1. Remove seat, left side panel, left footwell, and left
footwell support to gain access to PVT outer cover
(see Chapter 5 for removal).
2. Remove PVTair inlet and outlet ducts.
3. Remove outer PVTcover screws.
4. Mark the drive belt direction of rotation and remove
drive belt. See “Drive Belt Removal”.
Drive Clutch Puller:
(PN PA-48595) 9. Remove inner cover retaining bolts and Panduit®
strap.
Drive Clutch Holder:
(PN 9314177–A) 10. Remove cover along with foam seal on back of cover
or shaft.
5. Install the Drive Clutch Holder (PN 9314177–A) and
Remove drive clutch retaining bolt. ASSEMBLY
1. Inspect PVT inner engine cover seal. Replace if
cracked or damaged.
2. Place a new foam seal on transmission input shaft.

3. Apply RTV silicone sealant to outside edge of inner
engine cover seal, to ensure a water tight fit between
the seal and the cover. Surfaces must be clean to
ensure adhesion of silicone sealant.

6. Remove drive clutch using the Drive Clutch Puller
(PA-48595).
7. Remove the driven clutch retaining bolt and driven
clutch.

4. Reinstall cover and tighten rear cover bolts just
enough to hold it in place. Torque to specification
TORQUE
Inner Cover Screws (Hex), PVT
12 ft-lbs (16 Nm)

5.16 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.