Page 407 - Manual Oficina Polaris Sportsman 570 2014 a 2016

PVT SYSTEM

2. Inspect the drive belt to determine if the belt is riding 5. Remove the driven clutch bolt q, thrust washer w,
on the stationary or movable sheave. The belt should and offset washer(s) e.
be centered between the sheaves.

IMPORTANT
3. Remove the drive belt. Verify the belt is not worn,
burned, dished, or glazed. Ensure the inner and outer tapers are clean and free of 5
chips or burrs.

6. To achieve optimal belt alignment, add or remove
offset washers (PN 7556580) one at a time to center
the belt between the sheaves.
NOTE
Add washer(s) to move the belt closer to the drive
clutch movable sheave.
Remove washer(s) to move the belt close to the drive
clutch stationary sheave.

IMPORTANT
A minimum of 0 and a maximum of 6 washers may be
installed.
IMPORTANT
Ensure the correct belt is used. Belt part number should 7. Install the driven clutch bolt q, flat washer w, and
be 3211113.
offset washer(s) e. Torque the bolt to specification.
4. Measure the projected width of the drive belt. Use a TORQUE
straight edge across the top of the belt to provide a Driven Clutch Bolt:
more accurate measurement. Replace if necessary. 38 ft-lbs (52 Nm)
MEASUREMENT
Maximum Drive Belt Width: 8. Retest for PVT creeping and/or harsh gear selector
1.219” (30.96 mm) engagement. If symptoms persist, proceed to step 9.

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 5.21
© Copyright Polaris Industries Inc.