Page 488 - Manual Oficina Polaris Sportsman 570 2014 a 2016

FINAL DRIVE

REASSEMBLY / INSPECTION 5. Install the LH output hub (A) into the gearcase
housing. The output hub should spin freely.
1. Replace all O-rings, seals, and worn components.

2. Press the pinion shaft seal into the pinion cover, until 6. Install the RH output hub (B) into the output cover.
the seal is flush with the sealing surface. The output hub should spin freely.
3. Inspect bearings on output and pinion shafts. To
replace, press new bearing onto shaft.

NOTE
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement side to side.
4. Install input shaft, bearing, snap ring, and input cover
with new o-ring. Torque bolts to specification.

7. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.

TORQUE
Input Cover Bolts:
7-11 ft-lbs

7.12 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.