Page 486 - Manual Oficina Polaris Sportsman 570 2014 a 2016

FINAL DRIVE

8. Remove the LH output hub. Inspect the bearing and 11. Inspect roll cage (B) sliding surface. This surface
contact surfaces of the output hub for signs of wear must be clean and free of nicks, burrs or scratches.
or damage. Replace component if found to be worn Inspect the H-springs, but do not remove them
or damaged. from the roll cage.

9. Thoroughly clean all parts. Inspect the bearing 12. Inspect the armature plate for a consistent wear
surfaces of the output hub. Inspect the rollers (A) for pattern. Uneven wear of the armature plate indicates
nicks, scratches and flat spots. Inspect the roll cage a warped plate, which may cause intermittent
(B) for damage or cracks. The rollers must slide up operation.
and down freely within the roller cage surfaces.
NOTE
See “Troubleshooting, Front Gearcase (NON-ADC)”
later in this chapter for more details.

10. Inspect the ring gear (C) for inconsistent wear
patterns or damage. The surfaces should be free of
nicks or burrs.

7.10 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.