Page 490 - Manual Oficina Polaris Sportsman 570 2014 a 2016

FINAL DRIVE

13. Install the output hub and cover plate assembly with SETTING RING GEAR BACKLASH NON ADC
a new o-ring (arrow) onto the gearcase.
NOTE
Ring gear backlash is set at the factory. No adjustment
is required, unless the front cover is replaced or the
back lash pad screw is removed.

1. The backlash screw has locking agent that holds it
into place. Use a heat gun to lightly heat up the
locking agent on the screw.

NOTE
Verify the square O-ring (arrow) is placed flat on the
cover surface. If the O-ring is twisted, fluid leaks may
occur.

14. Torque the cover plate bolts to specification.

2. Using a hex wrench, turn the back-lash screw out 3-4
turns. Re-apply Loctite® 262™ onto the bottom
screw threads.

TORQUE

AWD Cover Screws:
8 ft-lbs (11 Nm)
3. Turn the screw in until it is lightly seated, then turn
the screw out 1/4 turn.
15. Lay the gearcase on the side with the output cover
facing up.

7.14 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.