Page 259 - Manual Oficina Polaris RS1 2018 e 2019
P. 259
PVT SYSTEM
DRIVE CLUTCH SERVICE
DRIVE CLUTCH REMOVAL 6. Remove nine fasteners t and remove outer clutch
cover.
1. Remove left rear fender (see Rear Fender, page
10.12 in the Body / Frame chapter).
2. Raise the vehicle.
3. Remove four lug nuts q and remove left rear wheel.
7. Mark the drive belt direction of rotation so that it can
be installed in the same direction. 5
8. Insert clutch spreader tool into the driven clutch and
turn the tool clockwise to open the sheaves on the
4. Remove lower fastener w from rear left-hand shock driven clutch.
assembly, and pivot the shock out of the way.
NOTE
The driven clutch spreader tool is included with the
5. Loosen two worm clamps e and remove clutch vehicle’s tool kit.
intake duct r from the outer clutch cover.
9. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
10.Hold the drive clutch using the drive clutch holding
tool and remove the drive clutch mounting bolt.
Drive Clutch Holding Tool:
PU-51861
9928689 - 2018 RZR RS1 Service Manual 5.7
© Copyright Polaris Industries Inc.
