Page 370 - Manual Oficina Polaris RS1 2018 e 2019

STEERING / SUSPENSION

FRONT STABILIZER BAR INSTALLATION BALL JOINT SERVICE PREPARATION

1. Install the fasteners r retaining the stabilizer bar link NOTE
to the stabilizer bar. Torque fasteners to specification.
Do not reuse a ball joint if it has been removed. If
TORQUE removed, it must be replaced. Use this removal
procedure only when replacing the ball joint.
Stabilizer Bar Link Fasteners:
40 ft-lb (54 Nm)
1. Properly lift and support the vehicle by the frame.
2. Remove the appropriate front wheel.
3. To service the upper ball joint: Remove and
discard the two front brake caliper mounting bolts and
remove the caliper from the brake disc (see “Caliper
Removal” in the Brake System chapter).

4. Remove and discard the upper ball joint pinch bolt.

5. If necessary, remove the lower front shock fastener
from the A-arm.
6. Remove the upper A-Arm to frame mounting bolts
and remove the A-arm from the chassis.
7. To service the lower ball joint: Remove and discard
the lower ball joint pinch bolt.
8. Remove both A-arm to frame mounting bolts and
remove the A-arm from the chassis.
2. Install the stabilizer bar from the side.
3. Install the fasteners retaining the stabilizer bar mount
to the frame. Torque fasteners to specification.
TORQUE
Stabilizer Bar Mount Bracket Fasteners:
20 ft-lb (27 Nm)

4. Install the nut q retaining the front stabilizer bar link
w to the upper control arm e on both sides. Torque
fasteners to specification.
TORQUE
Stabilizer Bar Link Fasteners:
40 ft-lb (54 Nm)

8.22 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.