Page 465 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

4. Press MODE to save and exit to the settings menu. The service interval counter is programmed to 25 hours
TRIP METER at the factory. As hours of engine operation increase, the
counter decreases. The wrench icon will flash for about
10 seconds when the counter reaches zero (0), and each
time the key is turned on thereafter, until the counter is
reset.
When this feature is enabled, it provides a convenient
reminder to perform routine maintenance. Refer to
“Periodic Maintenance Chart, page ” for
recommended service intervals
Use the following procedure to reset or change the
service interval:
1. Press and hold the MODE button to enter the settings
menu.
Use a trip meter to track the distance traveled during a 2. Press either toggle button to cycle to the “Service
specific trip or period of time. Reset the meter to zero Hours” option. Press MODE to select.
before traveling. 3. Press MODE to reset the existing value and exit, or
press either toggle button to change the value. Press
1. Press either toggle button to cycle to the desired trip MODE to save and exit to the settings menu.
meter option (T1 or T2).
2. Press and hold either toggle button until the meter
resets to zero. INSTRUMENT CLUSTER PINOUTS
TRIP TIME

FUNCTION PIN

Use a trip time meter to track the travel time during a CAN High 1
specific trip. Reset the meter to zero before traveling.
CAN Low 2
1. Press either toggle button to cycle to the trip time
option (TT). Switched Power (Vdc) 3
2. Press and hold either toggle button until the meter Constant Power (Vdc)
resets to zero. 4
PROGRAMMED SERVICE INTERVAL Ground 5
Left Turn Signal Input 6
Right Turn Signal Input 7
11
High Beam Input 8
Trailer Turn Sign Input 10

Fuel Level Sensor 11
Blackout Mode Input 12
Accy Air Temp Input 15

9928689 - 2018 RZR RS1 Service Manual 11.17
© Copyright Polaris Industries Inc.