Page 468 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

HEADLAMP SWITCH IGNITION / KEY SWITCH
1. Disconnect the headlamp switch harness by 1. Disconnect the key switch harness by depressing the
depressing the connector locks and pulling on the connector lock and pulling on the connector. Do not
connector. Do not pull on the wiring. pull on the wiring.
2. Test between the 3 sets of outputs (OFF / LOW / 2. Test between the 4 sets of outputs (OFF / ACCY / ON
HIGH). If any of the tests fail, replace headlamp / START). If any of the tests fail, replace ignition
switch assembly. switch assembly.
• Move the switch to HIGH. There should be continuity • In the OFF position, there should be no continuity
between switch pins 2 and 3; 5 and 6; 7 and 8. between any of the pins.
• Move the switch to LOW. There should be continuity • Turn the key to ACCY position. There should be
between switch pins 2 and 3; 4 and 5; 7 and 8.. contunity between switch pins A and B.
• Move the switch to OFF. There should be continuity • Turn the key to ON position. There should be
between switch pins 1 and 2; 4 and 5; 7 and 8. continuity between switch pins A, B and D.
• Turn the key to START position. There should be
continuity between all the pins on the switch.

NOTE
Pins 7 and 8 provide power and ground to light the
switch lamp.

11.20 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.