Page 469 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

AWD / 2WD SWITCH (NO TURF MODE) TRANSMISSION / GEAR POSITION SWITCH
1. Disconnect the AWD / 2WD switch harness by TESTING
depressing the connector locks and pulling on the 1. The transmission (gear position) switch q is located
connector. Do not pull on the wiring.
on the RH side of the transmission and can be
2. Test between the 2 sets of outputs (AWD / 2WD). If accessed through the rear RH wheel well area.
any of the tests fail, replace the switch assembly.
• Move the switch to AWD (ON). There should be
continuity between switch pins 2 and 3 as well as 3
and 7.
• Move the switch to 2WD (NONE / OFF). There should
ONLY be continuity between pins 3 and 7.

2. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
3. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.

RESISTANCE VALUE
GEAR
POSITION WHEN MEASURED AT SWITCH
TERMINALS A AND B
HIGH 620 Ω

LOW 300 Ω
NEU 160 Ω
REV 75 Ω
PARK 24 Ω

11

9928689 - 2018 RZR RS1 Service Manual 11.21
© Copyright Polaris Industries Inc.