Page 481 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

HEADLAMP INSTALLATION DASH LIGHT
1. Install the headlamp adjustment springs onto the The LED light will remain ON for approximately 30
front bumper mounting bosses. seconds after key has been switched to the OFF
position.
2. Insert the three T-25 headlamp mounting screws into
the headlamp assembly mounting holes.

3. Maneuver the headlamp assembly into position. Be
sure all three headlamp springs w and mounting
screws q are properly aligned with mounting bosses
e on the front bumper.

4. Fully tighten all three headlamp screws until the
headlamp assembly is fully seated. Back headlamp
mounting screws off 1/8” to 1/4” (2-3 turns).

5. Install the front bumper as shown in Chapter 5 if
previously removed.
6. Connect headlamp electrical connector to the
headlamp assembly.
7. Perform the “Headlight Adjustment” procedure as
shown in this chapter.

TAIL LIGHT REPLACEMENT
1. Disconnect the wire harness q.

11

2. While holding the taillight assembly, remove the four
nuts w retaining the taillight assembly and remove it
from the rear fascia.

9928689 - 2018 RZR RS1 Service Manual 11.33
© Copyright Polaris Industries Inc.