Page 484 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

STARTING SYSTEM STARTER MOTOR REMOVAL

TROUBLESHOOTING 1. Remove front hood and disconnect the battery
2. Remove drive and driven clutches (See Drive Clutch
Starter Motor Does Not Run Removal, page 5.7 and Driven Clutch Removal, page
5.16 in the PVT System chapter).
• Battery discharged
• Loose or faulty battery cables or corroded connections
(see Chapter 11 – Voltage Drop Test, page 11.36)
• Related wiring loose, disconnected, or corroded
• Poor ground connections at battery cable, starter
motor or starter solenoid (see Chapter 11 – Voltage
Drop Test, page 11.36)
• Faulty key switch
• Faulty starter solenoid or starter motor
• Engine problem - seized or binding (can engine be
rotated easily)

Starter Motor Turns Over Slowly
• Battery discharged
• Excessive circuit resistance - poor connections (see
Chapter 11 – Voltage Drop Test, page 11.36)
• Engine problem - seized or binding (can engine be
rotated easily)
• Faulty or worn brushes in starter motor
Starter Motor Turns - Engine Does Not Rotate

• Faulty starter drive
• Faulty starter drive gears or starter motor gear
• Faulty flywheel gear or loose flywheel

VOLTAGE DROP TEST
The Voltage Drop Test is used to test for bad
connections. When performing the test, you are testing
the amount of voltage drop through the connection. A
poor or corroded connection will appear as a high
voltage reading. Voltage shown on the meter when
testing connections should not exceed 0.1 VDC per
connection or component.
To perform the test, place the meter on DC volts and
place the meter leads across the connection to be tested.
Refer to the voltage drop tests on the starter system in
this chapter.

Voltage should not exceed
0.1 DC volts per connection

11.36 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.