Page 486 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

5. From the RH wheel well using an 8mm flex socket, STARTER MOTOR INSTALLATION
remove the negative battery cable nut w and the two
fasteners e securing the starter motor to the engine. 1. Inspect and replace starter motor O-ring if needed.
2. Lubricate starter motor O-ring with fresh engine oil.
3. Install the starter motor onto the engine case.
4. Hand tighten the upper starter mounting bolt / stud.
5. Install and torque the lower mounting bolt to
specification.
NOTE
Tighten the lower starter bolt first, as the bottom hole
acts as a pilot hole to properly align the starter drive
(bendix) with the flywheel. This helps prevent binding
and starter damage.

6. Torque upper starter mounting screw to specification.
7. Install (-) negative battery cable to the upper starter
mounting bolt / stud. Torque nut to specification.

NOTE TORQUE
The (-) negative battery cable is mounted to the engine Starter Mounting Bolts:
using the upper starter mounting bolt / stud. 7 ft-lb (10 Nm)
Starter Cable Nuts:
40 in-lbs (5 Nm)
6. Remove the starter from the engine.
NOTE 8. Install inner PVTcover
Tilt the engine slightly forward to gain enough clearance
to remove the starter.

11.38 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.