Page 487 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

TORQUE 10.Torque transmission mounting fasteners to
specification.
PVT Inner Cover Fasteners:
STEP 1: Torque to 37 ft-lbs (50 Nm).
STEP 2: Install through bolts by adjusting the
transmission accordingly.
STEP 3: If previously removed, loosely install bolts
by hand.
STEP 4: Torque to 37 ft-lbs (50 Nm).
STEP 5: Torque to 50 ft-lbs (68 Nm).
STEP 6: If previously removed, torque to 37 ft-lbs
(50 Nm)

NOTE
To aid in hole alignment, loosen transmission mount
fasteners t.

TORQUE
Transmission Mounting Fasteners:
22 ft-lbs (30 Nm)

11. Install the drive clutch. Torque bolt to specification.
TORQUE
Drive Clutch Retaining Bolt:
96 ft-lb (130 Nm)

12.Install the driven clutch. Torque bolt to specification.
TORQUE
Driven Clutch Retaining Bolt:
9. Connect three hinge clips connecting main harness to 40 ft-lb (54 Nm)
inner PVTcover.
13.With the clutch spreader tool installed, loop the belt
over the drive clutch and over part of the driven
clutch.
14.Rotate driven clutch and walk the belt into the clutch.
15.Remove clutch spreader tool from driven clutch.
16.Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven clutch.
17.Install outer clutch cover and nine screws. Torque to
specification.
TORQUE
Outer Clutch Cover Screws:
35 in-lb (3 Nm) 11

18.Install clutch intake duct, and tighten two worm
clamps to specification.
TORQUE
Worm Clamps
35 in-lbs (4 Nm)

9928689 - 2018 RZR RS1 Service Manual 11.39
© Copyright Polaris Industries Inc.