Page 488 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

19.Install rear left-hand shock into lower mounting point, STARTER SOLENOID BENCH TEST
install lower fastener into shock, and torque to Test the start solenoid by powering the solenoid using
specification. battery voltage for a maximum of 5 seconds. With the
solenoid energized, resistance should read about 0 - 0.5
TORQUE
Ω between terminals (A) and (B). If resistance
Lower Shock Mounting Fastener measurement is out of specification, replace the starter
70 ft-lbs (95 Nm) solenoid.

20.Install rear left-hand wheel. Torque to specification.

TORQUE
Wheel Lug Nuts
120 ft-lbs (163 Nm)

21.Install rear left fender.

STARTER SOLENOID OPERATION
To energize the Starter Solenoid the following must
occur:
• The brake must be applied to provide a ground path
via the Orange wire.
• The key switch must be turned to the “start” position to
provide 12V power via the Green / White wire.
• Once the pull-in coil is energized, the solenoid
provides a current path for 12V power to reach the
starter motor.

11.40 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.