Page 76 - Manual Oficina Polaris RS1 2018 e 2019

MAINTENANCE

STEERING TIE ROD END / WHEEL HUB INSPECTION

STEERING INSPECTION • To check for play in the tie rod end, grasp the steering
tie rod, pull in all directions feeling for movement.
The steering components should be checked periodically
for loose fasteners, worn tie rod ends, ball joints and
damage. Also check to make sure all cotter pins are in
place. If cotter pins are removed, they must be replaced.
Replace any worn or damaged steering components.
Steering should move freely through the entire range of
travel without binding. Check routing of all cables, hoses,
and wiring to be sure the steering mechanism is not
restricted or limited.

NOTE
Check front end alignment whenever steering
components are replaced.

WARNING • Replace any worn steering components. Steering
should move freely through entire range of travel
Due to the critical nature of the procedures outlined in without binding.
this chapter, Polaris recommends steering component • Elevate front end of machine so front wheels are off
repair and adjustment be performed by an authorized the ground. Check for any looseness in front wheel/
Polaris MSD certified technician.
hub assembly by grasping the tire firmly at top and
bottom first, and then at front and rear. Try to move the
wheel and hub by pushing inward and pulling outward.
STEERING WHEEL FREE-PLAY
Check steering wheel for specified free-play and
operation.
1. Position the vehicle on level ground.
2. Lightly turn the steering wheel left and right.
3. There should be about 0.8-1.0″ (20-25 mm) of free-
play.
4. If there is excessive free-play or the steering feels
rough, inspect the following components.
• Tie Rod Ends q
• Steering Shaft U-Joints w
• Steering Gearbox e

• If abnormal movement is detected, inspect the hub and
wheel assembly to determine the cause (loose wheel
nuts or loose front hub nut).
• Refer to Front Bearing Carrier Inspection / Removal,
page 7.3 and Rear Bearing Carrier Inspection /
Removal, page 7.6 for wheel bearing service
procedures.

2.54 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.