Page 81 - Manual Oficina Polaris RS1 2018 e 2019

MAINTENANCE

BRAKE SYSTEM BRAKE PAD INSPECTION
Measure the thickness of the pad material and backing
BRAKE HOSE AND FITTING INSPECTION plate with a caliper. Replace pads if worn beyond the

Check brake system hoses and fittings for cracks, service limit.
deterioration, abrasion, and leaks. Tighten any loose
fittings and replace any worn or damaged parts.
2
BRAKE FLUID INSPECTION

Always check the brake pedal travel and inspect the
brake fluid reservoir level before each operation. If the
fluid level is low, add DOT 4 brake fluid only.
Brake fluid should be changed every two years. The fluid
should also be changed anytime the fluid becomes
contaminated, the fluid level is below the minimum level,
or if the type and brand of the fluid in the reservoir is
unknown.
The brake fluid master cylinder reservoir can be
accessed through the left front wheel well.
1. Position the vehicle on a level surface. MEASUREMENT
2. Place the transmission in PARK. Brake Pad Thickness:
3. View the brake fluid level in the reservoir q. The level .296 ± .007″(7.53 ± .19 mm)
should be between the MAX and MIN level lines.
.180″ (4.6 mm)

4. If the fluid level is lower than the MIN level line, add
brake fluid until it reaches the MAX level line.
5. Install the reservoir cap and apply the brake pedal
forcefully for a few seconds and check for fluid
leakage around the master cylinder fittings and the
brake caliper fittings.

9928689 - 2018 RZR RS1 Service Manual 2.59
© Copyright Polaris Industries Inc.