Page 77 - Manual Oficina Polaris RS1 2018 e 2019
P. 77
MAINTENANCE
WHEEL TOE ALIGNMENT INSPECTION 5. Measure the distance between the marks and record.
Call this measurement e. Subtract measurement e
1. Place machine on a smooth level surface and set from measurement w, this is the vehicle toe. The
steering wheel in a straight ahead position. Secure recommended vehicle toe tolerance is 1/8 to 3/16″
the steering wheel in this position. (3.2 to 4.8 mm) toe out. This means the
2. Place a chalk mark on the center line of the front tires measurement at the front of the tire w is wider than
approximately 10″ (25.4 cm) from the floor or as close the measurement at the rear e. 2
to the hub/axle center line as possible q.
MEASUREMENT
Wheel Toe-Out:
1/8" to 3/16″ (3.2 to 4.8 mm)
NOTE
It is important the height of both marks be equally
positioned to get an accurate measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement w.
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
9928689 - 2018 RZR RS1 Service Manual 2.55
© Copyright Polaris Industries Inc.
