Page 264 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

Bushing Replacement Kit - 2871226 7. Flip sheave over so bushing faces downward and
install onto puller.
ITEM PART # TOOL DESCRIPTION 8. Install bushing removal tool t.
P-90 Drive/Driven Clutch
w 5020628 Bushing Install Tool

Drive Clutch Cover Bushing
e 5020629
Removal/Installation Tool
P-90 Driven Clutch Cover
t 5020631 Bushing Removal Tool

i 5020632 Main Puller Adapter
o 5010279 Adapter Reducer

a 5020633 Number Two Puller Adapter

NOTE
Bushings are installed at the factory using Loctite® 648. 9. Install left hand nut and spacer onto puller rod and
In order to remove bushings it will be necessary to tighten by hand. Turn puller barrel for further tension if
apply heat evenly to the area around each bushing. needed.
Clean all residual Loctite® from bushing bore prior to
installing new bushing.

CLUTCH BUSHING REMOVAL
1. Remove the driven clutch as previously outlined.
2. Install the handle end of the Piston Pin Puller
securely into the bench vise and lightly grease puller
threads.
Piston Pin Puller:
2870386

3. Remove nut from piston pin puller rod and set aside.
4. Install main puller adapter i onto puller.

10.Turn clutch sheave counterclockwise until bushing is
removed and sheave comes free.
11. Remove nut (left hand thread) from puller rod and set
aside.
12.Remove adapters from puller.
13.Remove bushing and removal tool from adapters.
Discard bushing.

5. Install adapter reducer o.
6. Using a hand held propane torch, apply heat around
outside of bushing until tiny smoke tailings appear.

5.32 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.