Page 265 - Manual Oficina Polaris RZR 570 13-18
P. 265
PVT SYSTEM
CLUTCH BUSHING INSTALLATION 7. Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
1. Install Number Two Puller Adapter a onto puller.
bushing is seated.
8. Remove nut from puller rod and set aside.
9. Remove installation tool and clutch sheave from
puller.
DRIVEN CLUTCH ASSEMBLY
1. Install a new bearing q onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
new snap ring w.
2. Install the Adapter Reducer o onto puller.
3. Apply Loctite® 648 evenly to bushing bore inside 5
moveable sheave.
4. Install sheave face down on puller.
5. Install new bushing on installation tool w and install
assembly into sheave.
2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
6. Install left hand thread nut onto puller rod and hand
tighten against installation tool.
NOTE
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
9926813 R06 - 2013-2016 RZR 570 Service Manual 5.33
© Copyright Polaris Industries Inc.
