Page 259 - Manual Oficina Polaris RZR 570 13-18

PVT SYSTEM

9. Remove the E-clip u, washer i and roller o. Check CLUTCH ASSEMBLY
both rollers in the stationary sheave for wear. If 1. Install the rollers, washers and E-clips.
rollers are worn, you must inspect the helix for wear.
If the helix roller surface a is worn down, a new 2. Align the “X” marks q on each of the sheaves.
driven clutch assembly will be needed.

3. Install the same thrust washers w between the 5
10. Inspect the bearings s inside the moveable sheave. sheaves as removed during disassembly.
If it is significantly worn, the clutch must be replaced.

4. Assemble the clutch sheaves by aligning the rollers
11. Inspect driven clutch sheave faces for wear or and the helix.
damage.
5. Position the spring washer (early build only), spring,
12. Clean and inspect splines on helix and transmission spring cup and retaining ring into moveable sheave.
input shaft. Do not apply oil or grease to the bearings.
13. Lube splines with a light film of grease. Do not
lubricate the bearings!

9926813 R06 - 2013-2016 RZR 570 Service Manual 5.27
© Copyright Polaris Industries Inc.