Page 327 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

BEARING CARRIER

FRONT BEARING CARRIER REMOVAL 5. Remove the two front brake caliper mounting bolts
1. Elevate front of vehicle and safely support machine y and remove the caliper from the brake disc.
under the frame area.

CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.

2. Remove the four wheel nuts and remove the front
wheel.
3. Remove the cotter pin q and hub castle nut w.
Remove the two cone washers e from the front
wheel hub assembly.

CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.

6. Remove the front wheel hub assembly.

7. Remove the upper and lower ball joint pinch
fasteners u.
7

4. Remove the cotter pin r and fasteners t retaining
the steering tie rod end to the front bearing carrier.

8. Using a soft faced hammer, lightly tap on the bearing
carrier while removing the upper and lower ball joint
ends.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.3
© Copyright Polaris Industries Inc.