Page 328 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

9. Remove the bearing carrier from the front drive shaft. 2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the three
relief locations as shown.

10. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion. 3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
11. Replace bearing if moisture, dirt, corrosion, or casting on outer edges so bearing can be removed.
roughness is evident.
4. Inspect the bearing carrier housing for scratches,
NOTE wear or damage. Replace front bearing carrier if
damaged.
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel. Bearing Installation
While rotating bearings by hand, inspect for rough 5. Thoroughly clean the front bearing carrier housing
spots, discoloration, or corrosion. The bearings should and the outer race on the new bearing. Be sure that
turn smoothly and quietly, with no detectable up and all oil residue has been removed from each surface.
down movement and minimal movement sideways
between inner and outer race. 6. Support the bottom of the bearing carrier housing.
CAUTION
FRONT BEARING REPLACEMENT Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
Bearing Removal
1. Remove the outer snap ringq. 7. Apply Loctite 603 retaining compound to the outer
®
®
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
NOTE
Use care to not allow any of the Loctite compound to
®
get in the bearing.

8. Wipe the housing clean of any excess compound
and install the snap ring.

7.4 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.