Page 332 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

REAR BEARING REPLACEMENT 7. Apply Loctite 603 retaining compound to the outer
®
Bearing Removal circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
1. Remove outer snap ring q. housing.
NOTE
®
Use care to not allow any of the Loctite compound to
get in the bearing.

8. Wipe the housing clean of any excess compound
and install the snap ring.

2. From the back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the relief slots
as shown.

3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect the bearing carrier housing for scratches,
wear or damage. Replace rear bearing carrier if
damaged.
Bearing Installation
5. Thoroughly clean the rear bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.

7.8 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.