Page 329 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

FRONT BEARING CARRIER INSTALLATION CAUTION
1. Install drive shaft axle through the backside of the New bolts have a pre-applied locking agent which is
bearing carrier.
destroyed upon removal. Always use new brake caliper
2. Install the upper and lower ball joint ends into the mounting bolts upon assembly.
front bearing carrier.
7. Install the steering tie rod end onto the front bearing
3. Install the ball joint fasteners u. Torque fasteners to carrier.
specification.
IMPORTANT
Refer to the photos below to ensure proper placement
of the tie rod end.

TORQUE
Ball Joint Fasteners:
23 ft-lb (31 Nm)
8. Torque the tie rod end fastener to specification and
4. Apply grease to drive shaft axle splines. install a new cotter pin. 7
5. Install front wheel hub assembly, cone washers e, TORQUE
and hand tighten the castle nut w. Install washers
with domed side out. Tie Rod End Fastener:
40 ft-lb (54 Nm)

9. Torque wheel hub nut to specification and install a
new cotter pin. Tighten nut slightly if necessary to
align cotter pin holes.

TORQUE
Front Wheel Hub Castle Nut:
80 ft-lb (108 Nm)
10. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:

6. Install brake caliper mounting bolts and torque to RZR 570 Steel Rims: 36 ft-lbs (49 Nm)
specification. RZR 570 EPS Alum. Rims: 120 ft-lb (163 Nm)
RZR S 570 Alum. Rims: 30 ft-lbs (41 Nm) + 90°
TORQUE
Front Caliper Mounting Bolts: 11. Rotate wheel and check for smooth operation. Bend
30 ft-lbs (41 Nm) both ends of cotter pin around end of spindle in
different directions.

9926813 R06 - 2013-2016 RZR 570 Service Manual 7.5
© Copyright Polaris Industries Inc.