Page 73 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

VALVE CLEARANCE INSPECTION 7. Rotate the drive clutch counter-clockwise until the
cam chain sprocket timing marks are aligned with the
NOTE gasket surface as shown (see Chapter 3 for more
TDC setting procedures).
Valve clearance inspection should be performed on a
cold engine, at room temperature. NOTE
2
1. Remove the seats and disconnect the negative (-) Intake cam sprocket should have “I” marks aligned with
battery cable. gasket surface and the exhaust cam sprocket should
have “E” marks aligned with gasket surface.
2. Remove the cargo box access panel.

3. Remove the spark plug wire from the engine and
remove the spark plug r. Place a clean shop towel
into the spark plug tube to prevent debris from
entering the combustion chamber.
4. Remove the three T40 bolts q retaining the valve
cover.

8. Measure the valve clearance of each valve using a
thickness (feeler) gauge. Record the measurement if
clearance is out of specification.

5. Remove the valve cover and seal e from the engine
out of the right-hand rear wheel well area.
6. Remove the outer PVTcover and drive belt as shown
in chapter 6.

9926813 R06 - 2013-2016 RZR 570 Service Manual 2.33
© Copyright Polaris Industries Inc.