Page 76 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

COOLANT LEVEL INSPECTION 8. Fill recovery bottle to MAX level with Polaris 50/50
The pressure cap q and recovery bottle w are located Extended Life Anti Freeze/Coolant as required for
under the front hood of the vehicle. The coolant level freeze protection in your area.
must be maintained between the minimum and 9. Reinstall the recovery bottle cap.
maximum levels indicated on the recovery bottle.
10. If coolant was required, start engine and check for
leaks. Make sure radiator fins are clean to prevent
overheating.

COOLING SYSTEM PRESSURE TEST
Refer to Chapter 3 for cooling system pressure test
procedure.

COOLANT STRENGTH / TYPE
Test the strength of the coolant using an antifreeze
hydrometer.

With the engine at operating temperature, the coolant
level should be between the upper and lower marks on
the coolant recovery bottle. If not, perform the following
procedure:
• Do not use tap water, straight antifreeze, or straight
1. Position the vehicle on a level surface. water in the system. Tap water contains minerals and
2. Remove the hood from the front cab. impurities which build up in the system.
• Using the 50/50 Extended-life antifreeze extends the
3. View the coolant level in the recovery bottle. service interval from two to five years.It is important to
4. If the coolant level is below the MIN line, inspect the note that 60/40 antifreeze can be mixed with 50/50
coolant level in the radiator. Extended Life antifreeze, however, mixing the two will
not extend the service interval.
NOTE • To receive the full five year service interval benefit, the
vehicles’s entire cooling system must be drained and
If overheating is evident, allow system to cool
completely and check coolant level in the radiator and replenished with the new 50/50 Extended Life
inspect for signs of trapped air in system. antifreeze.

WARNING
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
cap.

5. Remove the pressure cap. Using a funnel, add
coolant to the top of the filler neck.
6. Reinstall the pressure cap.

NOTE
Use of a non-standard pressure cap will not allow the
recovery system to function properly.

7. Remove recovery bottle cap and add coolant using a
funnel.

2.36 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.