Page 83 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

PVT / FINAL DRIVE / WHEEL AND TIRE

WHEEL AND HUB TORQUE TABLE WHEEL INSTALLATION
1. Verify the transmission is still in PARK (P).
TORQUE
2. Install the wheel hub q, washers w, and hub nut e,
Wheel Nuts: if previously removed. 2
RZR 570 Steel Rims: 36 ft-lbs (49 Nm)
3. Place the wheel r in the correct position on the
RZR 570 EPS Alum. Rims: 120 ft-lb (163 Nm) wheel hub. Be sure the valve stem is toward the
RZR S 570 Alum. Rims: 30 ft-lbs (41 Nm) + 90° outside and rotation arrows on the tire point toward
forward rotation.
TORQUE 4. Attach the wheel nuts t and finger tighten them.
5. Carefully lower the vehicle to the ground.
Hub Castle Nuts:
Front:80 ft-lb (108 Nm) 6. Torque the wheel nuts and/or hub nut to the proper
Rear:110 ft-lbs (149 Nm) torque specification listed in the torque table at the
beginning of this section.
NOTE 7. If hub nut was removed, install a new cotter pin y
after the hub nut has been tightened and install dust
Do not lubricate the stud or the lug nut. cap u.

WHEEL REMOVAL
1. Position the vehicle on a level surface.
2. Place the transmission in PARK (P) and stop the
engine.
3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the cotter pin and loosen the hub
nut slightly.

4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.
6. If hub removal is required, remove the hub nut and
washers. CAUTION

If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered rear
wheel nuts, make sure tapered end of nut goes into
taper on wheel.

9926813 R06 - 2013-2016 RZR 570 Service Manual 2.43
© Copyright Polaris Industries Inc.