Page 84 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

TIRE INSPECTION TIRE PRESSURE

• Improper tire inflation may affect vehicle CAUTION
maneuverability.
• When replacing a tire always use original equipment Maintain proper tire pressure. Refer to the warning tire
size and type. pressure decal applied to the vehicle.
• The use of non-standard size or type tires may affect
vehicle handling.
TIRE PRESSURE (COLD)
WARNING FRONT REAR
Operating with worn tires will increase the possibility of 7 PSI 9 PSI
the vehicle skidding easily with possible loss of control. 1 Rider (48 kPa) (62 kPa)
Worn tires can cause an accident. RZR 570
Always replace tires when the tread depth measures 1/ / EPS 8 PSI 10 PSI
8" (3 mm) or less. 2 Riders (55 KPa) (69 KPa)

10 PSI 10 PSI
RZR S 570
Tire Tread Depth (69 kPa) (69 kPa)
Replace tires when tread depth q is worn to 1/8" (3 mm)
or less.
DRIVE SHAFT BOOT INSPECTION
Inspect the front and rear drive shaft boots (Item 1) for
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced.
Check to see the boot clamps (Item 2) are properly
positioned. Refer to for drive shaft boot replacement.

BELT INSPECTION
1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.

2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.

2.44 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.