Page 81 - Manual Oficina Polaris RZR 570 13-18

MAINTENANCE

5. Locate throttle cable on the left-hand side of the ENGINE AND PVT INTAKE PRE-FILTER
throttle body. Slide back the cable adjuster boot. SERVICE
It is recommended that the engine and PVT intake pre-
filter be inspected daily. The filter should be inspected
using the following procedure:
NOTE 2

The engine and PVT intake pre-filter is located just
above the left-rear wheel fender.

1. Press “IN” on the intake grill cover tabs q and
remove the pre-filter cover.

6. Using an open-end wrench, loosen the adjustment
jam nut (A) . Using another open-end wrench, move
the cable adjuster (B) until 1/16 to 1/8″ (1.5 - 3 mm)
of free play is achieved at the throttle pedal.
NOTE
While adjusting, lightly move the throttle pedal in and
out.

7. Re-tighten the jam nut after final adjustment is made. 2. Remove and inspect the pre-filters w. If necessary,
clean with soapy water and dry with compressed air.
8. Apply a small amount of grease to the inside of the
boot u and slide it over the cable adjuster to its
original position.
9. Reinstall the cargo box access panel.

3. Reinstall the dry pre-filters and install the pre-filter
cover.

9926813 R06 - 2013-2016 RZR 570 Service Manual 2.41
© Copyright Polaris Industries Inc.