Page 118 - Manual_Polaris_RZR_ProXP-20-21

MAINTENANCE

10.Install the appropriate tappet into the cylinder head. CAM CHAIN TENSIONER INSPECTION
NOTICE 1. Locate the cam chain tensioner on the MAG side of
the engine near the starter.
Lubricate the outer portion of the valve bucket upon
installation. 2. Remove the plunger bolt q and the spring.

11. Repeat steps 10-14 until all necessary valves have
been adjusted.

12.Reinstall the camshafts and camshaft carriers and
tighten the bolts evenly to specification.
TORQUE
Camshaft Carrier Bolts:
7 ft-lb (10 Nm)

13.Measure and confirm that valve clearance is now
within specification for each valve.
14.If valve clearance is not within specification, repeat
this procedure.
3. Remove the two tensioner mounting bolts w.
15.If all valve clearance measurements are now within
specification, remove the camshaft carriers and 4. Push on the tensioner lock e and manually move the
proceed to Camshaft Installation / Timing page plunger in and out. It should move freely. If it does not
move freely, replace the tensioner assembly.

5. Retract the plunger all the way in and install into the
cylinder.

2.32 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.