Page 170 - Manual_Polaris_RZR_ProXP-20-21

ENGINE / COOLING SYSTEM

6. Slowly apply pressure to the actuator, and watch the 2. Holding the opposite 13mm hex nut, loosen the bolt
indicator dial. Once the indicator dial has indicated a securing the heim joint with a 4mm Allen key.
displacement of .070″ (1.75 mm), observe the line
pressure reading after the air pressure regulator.
NOTICE
The intended actuator preload should result in a
displacement of .070″ (1.75 mm) at 7 PSI supplied air
pressure. Having a correctly preloaded actuator will
help ensure correct turbocharger response and boost
pressure.

MEASUREMENT
Actuator Preload
0.070” (1.75 mm) at 7 PSI (48.3 kPa)

7. To adjust actuator preload, start by loosening the two 3. Remove both pieces to free the Heim joint from the
(13mm) lock nuts on the actuator rod, keeping in assembly.
mind the actuator rod itself is a left hand thread.
4. On the opposite end of the turbocharger, locate M6
10mm hex bolts that fasten the actuator pod bracket
to the compressor housing, as well as the boost
pressure reference hose on the top of the canister.

8. Using the same method of applying air pressure to
the canister as previously mentioned, the large
turnbuckle can be turned to adjust actuator preload,
until the desired preload is met. This correct preload
will result in .070″ (1.75 mm) of displacement on the 5. Remove the boost reference hose from the canister
wastegate flapper at a supplied pod pressure of 7 pod.
PSI. The nuts may be locked in place once again 6. Remove the two mounting bolts, and the actuator pod
using the (17mm) flats found on the actuator rod assembly will be free from the turbocharger.
turnbuckle.
NOTICE CAUTION
The preload may change when the lock nuts are Do NOT hold turbocharger by the actuator rod. This
torqued. Ensure the correct preload is still measured may result in serious damage to the turbocharger and
after locking the actuator rod turnbuckle in place. its components.

7. For assembly, reverse procedure. Torque fasteners to
specification.
ACTUATOR POD REMOVAL
TORQUE
1. Locate the actuator rod heim joint, located opposite to
the actuator pod. Actuator Rod Heim Joint Fasteners:
7 ft-lb (10 Nm)

3.26 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.